Stop Corrosion Before It Starts
Extend the life of your investment with a product designed to tackle saltwater corrosion before it can do lasting harm.
See how Salts Gone® shields your equipment
You already know that salt is corrosive to your boat, trailer, reels, etc. You also know it's unavoidable, and cleaning the boat is the worst part of the day!
Salts Gone® is an instantly acting chelating agent for salt/brine, making clean-up as easy as a spray and rinse.
There are three primary components to it:
- Chelating agents for the various forms of salt
- Corrosion inhibitors to prevent future salt from causing further damage
- Surfactants (soap)
Salts Gone® is:
PH Neutral
- This means it's safe on any material you would find on a boat, including metals, glass, paint, ceramic coatings, wax, vinyl wraps, SeaDek, electronics, screens, reels, trailers, etc.
Highly Concentrated
- Each gallon makes one hundred gallons of finished solution (1:100)
Can be applied with or without running water
- Running water: Hose End Sprayers, injector boxes, pressure washers
- No running water: Pump Sprayers, Battery operated sprayers
Salts Gone® does not emulsify oil
This means it's safe to use on your reels
Read More on Preventing Corrosion
Salts Gone FAQs
A good rule of thumb: if the surface can safely get wet, it’s safe for Salts Gone®.
Use it without worry on:
- Wax and ceramic coatings
- Gelcoat, paint, vinyl wraps, and SeaDek
- Trailers, rods, reels, and outboards
- Screens, glass, and marine electronics
Water only moves salt, it doesn't eliminate it.
Salts Gone® breaks the chemical bond of salt on contact and leaves corrosion inhibitors behind. Rinsing alone just pushes salt into tight spaces where rust thrives.
Salts Gone® is not designed to remove rust. However, many users report that soaking lightly rusted parts in undiluted concentrate can help lift surface rust thanks to the corrosion inhibitors.
Salts Gone is meant to be used on an "as needed" basis. We recommend using Salts Gone® after every trip on the water.
Frequency for other surfaces (trailers, vehicles, docks, etc.) depends on how often they’re exposed to salt.
Most customers cut their cleanup time by 60–80%. What used to take 20–30 minutes now takes just 5–10 minutes with Salts Gone®. Spray it on, rinse it off, no scrubbing required.
For simple salt removal, no scrubbing is needed. Just spray and rinse.
For heavy dirt or grime, a quick brush or sponge may help activate the built-in surfactants.
Usually not. Salts Gone® contains surfactants (soap), so most boaters replace their boat wash with it.
For heavy-duty messes (like fish blood and guts), you'll need something extra (check out our fishing wipes).
One 32 oz Hose End Sprayer produces up to 25 gallons of ready-to-use solution. That's enough to treat a 24-foot bay boat around 4–6 times or a pickup truck around 5–7 times, depending on coverage and conditions.
Yes, Salts Gone® is eco-friendly, biodegradable, and non-hazardous. It’s safe for use around docks, water runoff areas, and the environment.
Not if you're using our Hose End Sprayer. It does the mixing for you.
If you're using a pump sprayer or injector, dilute at a 1:100 ratio (that’s 1.28 oz per gallon of water).
No, Salts Gone® was specifically designed not to emulsify oil, making it safe on lubricated parts like reels, hinges, and bearings.
Slide to compare a Sea-Doo before and after Salts Gone®!
A big thank you to our amazing customers for sending in photos and videos!
Upload a review or send us your Salts Gone® content to receive a free gift card from us
Prefer faster delivery? Get same-day or next-day shipping with Amazon Prime!